The
H.01L oil / water interface meter is used to accurately
measure the thickness of floating product (LNAPL)
above the water table. It will also detect and
measure sinking layers of DNAPL. The H.01L with
its slim probe 5/8in (13mm), is ideal for wells,
piezometers and direct push equipment as narrow
as 3/4in (19mm) ID. The probe and tape will withstand
hydrocarbons, solvents and other contaminants.
This unit is used by professionals involved with
the monitoring and remediation of groundwater
contaminated by oil products. The H.01L interface
meter is suitable for wells, boreholes, underground
and above ground storage tanks.
FEATURES
Able to measure product layer 1/200th ft (1
mm) thick
Certified Intrinsically Safe to CSA/NRTL, Class
1.GR A. B.C. D.
Accurate (complies with US GGG-T-106E standards)
Kynar® jacketed, high tensile steel tape
with stretch proof
stainless steel conductors
The standard tapes are marked in feet and 100th/ft
or
meters and mm
Standard tape lengths are 50ft, 100ft, 150ft
and 200ft to
1000ft in steps of 100ft (15m, 30m, 50m, 100m,
thereafter
in 50m increments). Intermediate lengths are
to special order
Ultra-slim 5/8" (15mm) diameter stainless
steel field
replaceable probe*
Unique flexible link between the tape and the
probe provides protection at this vulnerable
point
Probe sleeve, removable to allow the probe to
be used in
Narrow Wells
Durable U.V. and high impact resistant engineered
plastic
reel with all stainless steel fittings
Sturdy polyester coated steel frame with a comfortable
vinyl grip and "third hand" built
in casing hanger that allows you to hang the
unit on the well while you record results
Water and dust proof epoxy encapsulated electronics
on an easily removable front electronics panel
One easy to change 9 V battery located on the
faceplate
electronic panel
Complete with a tough nylon carrying bag and
a comprehensive cleaning kit
10 year limited warranty
|
|
The
Model 122 Interface Probe from Solinst is only
5/8"(16mm) in diameter. It can be used within
narrow drive-in equipment and in 1" (25mm)
wells. It accurately measures the depth and thickness
of non-aqueous product layers (DNAPL & LNAPL)
in monitoring wells and tanks.It is easy-to-use,
sturdy and inexpensive to repair. Batteries give
120 hours of use. Probe has an automatic shut-off
after 10 minutes. Easy access battery drawers
simplify battery replacement. Lengths from 50
- 1500 ft. (15m - 450m). If a bigger dia. probe
is preferable for deeper applications Solinst
also has a 1.5" dia. model.
The
non-stretch tape uses 7 strands of stainless
steel in each side of the dog bone design, and
is easily repaired. Permanent heat embossed
markings are very accurate and traceable to
national standards. The redesigned reel gives
improved ergonomics and better stability.
FEATURES
Enhanced electronics for superior performance
Intrinsically safe for use in explosive environments
Sensor accuracy to 1/200 ft. (1.0 mm)
|
|